Chapter 2: General Operation; Switching On; Switching Off - TCL L26E9AD Operation Manual

Chapter 2
POWER
POWER
POWER

Switching on

Follow the instructions on this page on how to switch on your TV set and the remote
control before going on to following pages describing how to use the channel set-up
procedure.
1. Insert two AAA batteries in the remote control.
Precautions on using batteries:
- Only use the battery types specified.
- Make sure you use the correct polarity.
- Do not mix new and used batteries.
- Do not use rechargeable batteries.
- Do not expose batteries to excessive heat, throw them in a fire, recharge them
or try to open them, as this could cause them to leak or explode.
- Remove the batteries from the remote control if you are not using it for a long
period of time.
2. Connect the power cable FIRST to the television, THEN to a mains socket.
Your TV set should only be connected to an AC supply. It must not be connected
to a DC supply. If the plug is detached from the cable, do not, under any
circumstances, connect it to a mains socket, as there is a risk of electric shock.
Note: The figures are for representation only. The location of the power socket at
the back of the television might differ depending on the model.
3. Connect the outside aerial or cable network to the ANTENNA IN socket at the
back of the TV set.
The aerial socket (75 OHM - VHF / UHF / cable) can be used for connecting
an external aerial or other equipment fitted.
4. Switch the TV on by pressing the AC power button located at the back.
If the power indicator light up (buttons on the side of the TV), the TV set is in standby
mode. Press the button on the remote control or the PRO.
at the side of the TV set to turn on the TV.

Switching off

To put the TV set into standby mode, press the
press the POWER button at the side of the TV set
but with low energy consumption.
To switch off the TV set, press the power button at the back
7
General Operation
, POWER buttons
button on the remote control or
. The TV set remains powered up,
.