Included Items - Epson ELPSC21 User Manual

Included Items

Screen
Part Names (Completion drawing)
Screen Stand
1 2
Setting Up
1
Take out the screen, stand, shafts, and stabilizer
from the storage case.
2
Set up the stand.
Push down the tripod lever and extend the tripod.
1
The tripod lever should be on the rear side of the
screen.
Caution
If the tripod is not extended completely, it could fall
and cause an injury.
Attach the stabilizer to the front leg of the tripod. Slide
2
the stabilizer so that both the front leg and the bottom
of the stabilizer sit on the floor.
* Make sure you always use the stabilizer. If you set up
the screen without using the stabilizer, it may fall and
cause an injury.
3
Insert the shafts into the holder.
Match the numbers on the shafts with the numbers on the
1
label on the back of the holder.
Insert the shafts with the
2
holder, and with
the shafts with all the labels facing the same direction until
you hear a click.
When hanging the screen on a wall.
Remove the screw at the
1
junction of the holder
and extension pole and
remove the holder before
inserting the shafts.
3
Stand Stabilizer
Shafts Stabilizer
3 4 5
Push the tripod lever all the way
down.
labels into the
1
labels into the holes of the holder. Insert
2 2
Shafts (four pieces)
Tripod Tripod lever
6 7
holes on the
1
Twist a string or a wire around
2
the upper ends of the top two
shafts (label
1
Mobile Screen (X type)
ELPSC21/ELPSC21B
Warnings and Precautions
Read this document carefully to use this product safely and correctly. Keep this information with the screen so that
it can be used to solve any problems that arise.
Explanation of symbols
Warning
Caution
Do not set up the screen near any kind of heater or cooker.
The screen is made from plastic materials and may catch fire.
Do not set up the screen on a slanted or unstable surface.
It could fall over and cause an injury.
Extend the tripod properly and steady the screen before using it.
If you install or remove the screen without extending the tripod properly, it could fall and cause an injury.
Do not hang from the screen or hang any objects on the screen.
If there are young children in the house, make sure that they do not play with the screen.
It could pinch their fingers, or fall over and cause an injury.
Do not disassemble or modify the screen.
Parts may spring out and cause an injury.
Be careful not to pinch your finger when setting up or storing the screen and stand.
Be careful when storing the screen.
The screen could fall and cause an injury.
Do not set up the screen where it is exposed to wind or drafts.
The screen may be blown over if it is set up outdoors, in front of an open window, or in front of a fan or air
conditioner. If the screen falls, it may cause an injury.
Do not play with the shafts or use them for other purposes.
Problem Solving
If you notice any damage or anything unusual, stop using the screen immediately and contact the store where you
purchased it.
Notes on Disposal
Dispose of the screen properly in accordance with your local regulations. If relevant, follow company regulations.
Refer to the following for more information.
Screen material: Polyvinyl chloride
Stand material: Steel/Aluminum

User's Guide
Storage case
Stand parts
Adjuster Extension pole
8
).
This symbol indicates information that, if ignored, could possibly result in personal
injury or even death due to incorrect handling.
This symbol indicates information that, if ignored, could possibly result in personal
injury or physical damage due to incorrect handling.
Warning
Caution
Storage case material: Nylon
Shaft material: Aluminum
(this guide)
Holder
9