Wiring Diagram - Makita BUH550 Technical Information

W
iring diagram
Fig. D-2
Lead Wires of Brush Holder
Fix Lead wires with Lead wire holders
on Yoke unit side.
Lead wire
holders
Yoke unit side
Fig. D-4
Lead wire holder
Line Filter (if used)
Put Line filter between
Lead wire holder and
Controller.
Controller
Fig. D-3
Brush holder
Line filter
(if used)
Motor Housing
Brush holder
Put Insulated connectors
in this place.
Line Filter and Brush
holders' Lead wires
• Line filter's position has to be adjusted that it
distances max. 30 mm from the rib for Yoke unit.
• Two lead wires from Brush holder have to be
coiled around Line filter one turn.
max.
30 mm
Rib for Yoke unit
Fix Lead wires in these Lead wire holders.
Line Filter (if used)
• Lead wires (black, red) to Insulated
connector have to be passed through
Line filter.
• Slack portion of lead wires have
to be stored in this place.
Front grip switch
P 8/ 9
Lead wire (black)
of Brush holder
Lead wire (red) of
Brush holder
Line filter (if used)
Fix Lead wires in
these Lead wire holders.