Initial Setup And Default Login; Installation; Default Login; Diskless Units - NETGEAR Ultra 6 Hardware Manual

Hide thumbs Also See for Ultra 6:

Table of Contents

Initial Setup and Default Login

To install your ReadyNAS Ultra, follow the instructions in the NETGEAR ReadyNAS for

Home Installation Guide that came with your unit.

An electronic copy of the installation guide is located on the product CD.

You can also find it on the NETGEAR ReadyNAS Community support page at

http://readynas.com/documentation.

Estimated setup time is about 20 minutes.

To log in to your unit:

Open a web browser and enter the following URL in the address field:

The default IP configuration is set to DHCP; if the unit does not automatically get an IP

address, it defaults to 192.168.168.168.

At the login prompt, enter the authentication information:

a. Default administrator user name: admin

b. Default password: netgear1

Both the user name and password are case-sensitive.

For information about using ReadyNAS RAIDar and FrontView software to log in, configure,

and manage your system, see the ReadyNAS for Home Software Manual.

If your unit did not come with disks already installed (a diskless unit) you will need to install

the disks and then install and configure RAID before proceeding.

Go to

http://www.readynas.com/hcl

Home Software Manual for instructions on installing disks and configuring RAID.

10 |

Chapter 1: Getting Acquainted

for a list of supported disks. Refer to the ReadyNAS for

ReadyNAS Ultra Hardware Manual

Table of Contents

Ultra 4