Kenmore 110.2713 Series Use & Care Manual page 13

CLEANING YOUR DISPENSER
You may find laundry product residue leftover in your dispenser
drawer. To remove residue, follow this recommended cleaning
procedure..
1o Pull drawer out until you feel resistance.
2. Push ] tab downward, and then continue pulling out.
3. Wash in warm, soapy water, using a mild detergent.
4. Rinse with warm water.
5o Air dry, or dry with a towel_ then place back into slot.
e
Q
Q
iMPORTANT: Dispenser drawer and tray are not dishwasher
safe.
r
WINTER STORAGE CARE
iMPORTANT: To avoid damage, install and store washer
where it wJJJnot freeze. Because some water may stay in
hoses, freezing can damage washer. If storing or moving
during freezing weather, winterize your washer.
To winterize washer:
1. Shut off both water faucets; disconnect and drain water
inlet hoses.
2. Put 1 qt. (1 L) of R.V.-type antifreeze in basket and run
washer on RINSE & SPIN cycle for about 30 seconds to
mix antifreeze and remaining water.
3. Unplug washer or disconnect power.
f
-- TRANSPORTING YOUR WASHER
1. Shut off both water faucets. Disconnect and drain water
inlet hoses.
2. If washer will be moved during freezing weather, follow
WINTER STORAGE CARE directions before moving.
3. Disconnect drain from drain system.
4. Unplug power cord.
5. Place inlet hoses inside washer basket.
6. Drape power cord and drain hose over the console and
secure with masking tape.
Z Place foam packing ring from original shipping materials
back inside washer. If you do not have packing ring, place
heavy blankets or towels into basket opening. Close lid
and place tape over JJd and down front of washer. Keep
lid taped until washer is placed in new location. Transport
washer in upright position.
REINSTALLiNG/USING WASHER AGAIN
To reinstall washer after non=use, vacation, winter storage or
moving:
1. Refer to Installation instructions to Iocate_ level_ and
connect washer.
2. Before using again, run washer through the following
recommended procedure..
To use washer again:
1. Flush water pipes and hoses. Reconnect water inlet hoses.
Turn on both water faucets.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
2. Plug in washer or reconnect power.
3. Run washer through Bulky/Bedding cycle to clean washer
and remove antifreeze, if used. Use only HE High Efficiency
detergent. Use half the manufacturer's recommended
amount for a medium=size load.
13