Bosch PTK 3,6 LI Original Instructions Manual page 35

OBJ_BUCH-1433-005.book Page 35 Tuesday, August 19, 2014 11:25 AM
Tack Paper (see figures C1–C2)
– Insert a suitable staple strip 9 .
– Click the lugs of the paper tacker 11 one by one into the side slots of
the power tool.
– Insert the stack of paper into the paper tacker 11 and position the tack-
er head over the paper surface to be tacked.
– Firmly push the power tool down until the tacker head 1 is pushed in a
few millimetres.
– Keep up the contact pressure and briefly press the trigger 5.
Once the staple has been completely driven in, release the trigger 5
and lift the tacker head 1 from the stack of paper.
Note: To load the magazine, you have to dismount the paper tacker from
the cordless tacker.
Tack Booklets (see figures D1–D3)
– Before the first use, you must put the two halves of the booklet maker
12 together.
The booklet maker can no longer be dismounted.
– Insert a suitable staple strip 9 .
– Fold the top sheet (cover) of the stack of paper to be tacked in half, in
order to obtain an indication line for the staple position.
– Open the brackets 13 of the booklet maker 12 and place the paper
stack in the middle, with the cover facing upwards.
– Fold the brackets 13 downwards.
Align the paper stack in such a way that the indication line is visible
through the slots of the brackets.
– Firmly place the tacker head 1 against one of the slots first, until it is
pushed in a few millimetres.
– Keep up the contact pressure and briefly press the trigger 5.
Once the staple has been completely driven in, release the trigger 5
and lift the tacker head 1 from the bracket.
– Repeat the steps for the second slot.
– Lift back the brackets 13, remove the tacked paper stack and fold it in
half.
Bosch Power Tools
English | 35
1 609 92A 0PU | (19.8.14)