Toro Z Master Professional 6000 74922 Operator's Manual page 59

10. Fine-tune the adjustment nut on the front deck lift
assembly by turning it
Note: To increase the height, turn the adjustment nut
clockwise; to decrease, turn counterclockwise.
Note: If the front deck links do not have enough
adjustment to achieve accurate cut height, the
single point adjustment can be utilized to gain more
adjustment.
2
1
g027344
Figure 90
1. Adjustment nut
2. Jam nut
11. To adjust the single-point system, loosen the 2 bolts at
the bottom of the height-of-cut plate
(Figure 90).
3 4
2 1
3. Rear deck adjustment
4. Front deck adjustment
(Figure 91).
1. Bolts at the bottom of the height-of-cut plate
12. If the deck is too low, tighten the single point
adjustment bolt by rotating it clockwise. If the deck is
too high, loosen the single point adjustment bolt by
rotating it counterclockwise
Note: Loosen or tighten the single-point adjustment
bolt enough to move the height-of-cut plate mounting
bolts at least 1/3 the length of the available travel
in their slots. This will regain some up and down
adjustment on each of the 4 deck links.
1. Single-point adjustment bolt
13. Tighten the 2 bolts at the bottom of the height-of-cut
plate (Figure 91). T
Note: In most conditions, the back blade tip should
be adjusted 6.4 mm (1/4 inch) higher than the front.
14. Torque the 2 bolts to 37 to 45 N-m (27 to 33 ft-lb).
59
Figure 91
(Figure 92).
g017036
Figure 92