Wiring Connection - Kenwood KDC-200UB Instruction Manual

Wiring connection

Antenna terminal
Connecting the ISO connectors on some VW/Audi or
Opel (Vauxhall) automobiles
You may need to modify the wiring of the supplied
wiring harness as illustrated below.
A7 (Red)
Vehicle
A4 (Yellow)
Default wiring
Pin Color and function
A4 Yellow : Battery
A5 Blue/White : Power control
A7 Red : Ignition (ACC)
A8 Black : Earth (ground) connection
B1 Purple ]
: Rear speaker (right)
Purple/black [
B2
Gray ]
B3
: Front speaker (right)
Gray/black [
B4
B5 White ]
: Front speaker (left)
B6 White/black [
Green ]
B7
: Rear speaker (left)
Green/black [
B8
Front/ Rear/ Subwoofer
output
Fuse (10 A)
Yellow (Battery wire)
Ignition wire
(Red)
Red (Ignition wire)
Unit
Battery wire
(Yellow)
Red (A7)
Yellow (A4)
ISO connectors
If your car does not have an ISO terminal :
We recommend installing the unit with a
commercially available custom wiring harness
specific for your car and leave this job to professionals
for your safety. Consult your car audio dealer.
*
: Not available
If no connections are made, do not let the wire come out
from the tab.
STEERING WHEEL
Light blue/yellow
REMOTE INPUT To the steering wheel
(Steering remote
REMOTE CONT remote control adapter
control wire)
To the power control
terminal when using the
Blue/White
ANT CONT
optional power amplifier
(Power control
P. CONT
or to the antenna control
wire/ Antenna
terminal in the vehicle
control wire)
To the terminal that
Brown
is grounded when the
(Mute control
MUTE
telephone rings or during
wire)
conversation ( 14)
(To connect the Kenwood
navigation system, refer your
navigations manual.)
When connecting to an
external amplifier, connect
its ground wire to the car's
chassis to avoid damaging
the unit.
Part list for
installation
(A) Faceplate
(B) Trim plate
(C) Mounting sleeve
(D) Wiring harness
(E) Extraction key
17
ENGLISH