SENS./GAIN (input sensitivity/amplifier gain)
Sets the input sensitivity or the amplifier gain.
NOTE
Refer to
"Input sensitivity and amplifier gain" (page 7)
gain.
SP SERIES (speaker series)
Selects a speaker series for connection from models registered in the PX amplifier.
NOTE
When a speaker is selected, filters, speaker impedance, and threshold of the limiter are set auto-
matically. If the speaker for connection is not in the menu, select "GENERIC."
SP MODEL (speaker model)
Specifies a speaker for connection from the speaker series selected in SP SERIES screen.
for details on input sensitivity and amplifier
Panel Operation — CONFIG WIZARD screen (Advanced mode)
SP IMPEDANCE (speaker impedance)
(If "SP SERIES" is "GENERIC")
Sets the impedance of the speaker for connection.
CONFIRMATION
Applies the set value.
After confirming the setting is appropriate, press the main knob to actually apply the set
value.
To change or correct the setting, press the [
To cancel the setting, press the [MENU] key or press and hold the [
confirmation screen appears.
] (back) key to return to the previous screen.
] (back) key until a
PX10/PX8/PX5/PX3 Reference Manual
24