Installation; Cautions For Operation - Toshiba GR-W77MD Owner's Manual

安装
■ 初次打开冰箱门时，可能会有塑料的气味。这并非异常情况。
■
冰箱应放置于干燥处。
不宜把冰箱置于潮湿的地方，例如，厨房的水槽附近。否则会导致
冰箱锈蚀或漏电。如直接放在地面上，则应在下面垫上木板等，否
则也易损坏机器。
■
安装。
将东芝冰箱安装在坚固⽔平的地⾯上。转动调整腿使冰箱保持⽔平。
■
冰箱四周要留有空隙。
放置冰箱的地方需要良好的通风条件。上面及后部
至少要有 10 cm 空间，两侧各有 4 cm ，以便空
气流通。
■
在阴凉处使用。
■
远离阳光直射处及煤气炉或其它热源。
如果冰箱受阳光直射，或放置在其它热源附近
则会导致制冷效果下降，甚至产生故障。
信息
•
压缩机放热
在正常工作情况下，冰箱的压缩机要向外放出热量。
•
冰箱外壁上的热量
冰箱的冷凝器装于冰箱的外壁内，并通过冰箱外壁将热量散到室内。在
正常工作时，冰箱外壁的温度会很高这并非冰箱发生故障。
•

冰箱的运转
初次接通电源时，或持续断电后重新接通电源时，冰箱会连续运转 9 至
14 小时，以使整个箱内温度降到正常运行温度。当箱内温度达到稳定
后，冰箱即转入自动控温状态，在上述情况下，冰箱连续运转。请记
住，这并非故障现象。



操作时的注意事项
从墙壁电源插座上拔下电源插头后，请等待⾄少 7 分钟再重新连接。
如果在短时间內重新插⼊插头，则压缩机可能⽆法正常运⾏且会发⽣很
•

响的噪⾳。
移动和运输时
•
⾸先，取出⾷品。
搬运时，请握住图⽰位置
•

（切勿握住门或把⼿）。
搬运并重新放置时
正面下侧
请勿将冰箱沿侧⾯躺下。 Front lower side
•
否则可能导致故障。
部件的识别和功能
LED Light
LED
Freezer Shelf
Ice Tray
Ice Box
Meat Case Cover
Meat Case
Control Panel
(Freezing Compartment)
Control Panel
(Refrigerator Compartment)
LED Light
LED
Crisper Shelf
Vegetable Crisper
Adjust Leg
⾄少 10 cm
at least 10 cm
⾄少 10 cm
⾄少 4 cm
at least 10 cm
at least 4 cm
后部上侧
Rear upper side
Shelf
–4–

INSTALLATION

■
When you open the door of the refrigerator, there may be a smell of
plastics. This signifies nothing unusual.
■
Select a dry place.
Avoid any humid or wet place, for example, the neighborhood of a kitchen sink.
Such a place could cause corrosion or electric leakage in the refrigerator.
If installed directly on the ground, your refrigerator will be liable to damage.
Place a board under the machine in such a case.
■ Installation
Install your Toshiba Refrigerator on a strong and level floor. Turn the adjust leg
and stabilize the refrigerator horizontally.
■
Leave space around the refrigerator.
Select a well-ventilated place. Provide at least 10 cm (4 inches) at top and
rear sides and 4 cm (1.6 inches) on both sides for proper air circulation.
■
Use in a cool place.
Keep the refrigerator away from the sunlight, a gas range or heater.
■
Placed in the sunlight or near a heat emitting object, the refrigerator will have its
cooling effect reduced and a failure might be occured.
INFORMATION
•
Heat Generation by the Compressor
The refrigerator compressor will generate heat during normal operation. Note
that this is not a malfunction.
•
Heat on Refrigerator Walls
The condenser is built on the outer shell and radiates heat into the room air.
The temperature of the outer shell may reach high temperature during normal
refrigerator operation. This is not a malfunction.
•
Refrigerator Operation
When the power is first turned on or when the power comes on again after an
extended power outage, the refrigerator may run continuously for 9 to
14 hours in order to cool the entire cabinet to the normal operating temperature.
When the inside temperature has stabilized, the refrigerator will enter the
automatic control mode. Should the refrigerator run continuously under the
above conditions, remember that this is not a malfunction.

CAUTIONS FOR OPERATION

After disconnecting the plug from the outlet, wait at least 7 minutes
before reconnecting it.
•
If the plug is quickly reconnected, the compressor may not run properly and
produce a rattling noise.
When moving and transporting
•

Firstly, remove the food.
•

When carrying, hold the positions shown in the diagram.
(Never hold by the door or the handle.)
When transporting while relocating
•
Do not lay the refrigerator on its side. Doing so may cause malfunction
IDENTIFICATION AND
FUNCTIONS OF PARTS
Freezer Door Pocket
Egg Rack Part-A
Egg Pocket
Hybrid LED Deodorizer
Mini Pocket
Utility Box
Utility Cover
Bottle Pocket Upper
Bottle Stopper
Bottle Pocket Lower
(*Should not contained
with bottle high over range
between Bottle Pocket
Upper and Bottle Pocket Lower and
may cause door cannot closed.)
.
A
LED
*