Osd Lock & Service Modes - Philips 109P2 CM25 GSIII Service Manual

6 109P2 GS3 CM25
Go to cover page
To lock (disable) OSD function:
- Press OSD button " " for over 15 seconds to lock the OSD function.
Release it, then OSD comes on the screen as below.
ATTENTION
CONTROL MENU IS LOCKED
To unlock (enable) OSD function:
- Press OSD button " " for over 10 seconds again to unlock the
OSD function.
Release it, then OSD comes on the screen as below.
Disable/Enable all the WARNING SIGNAL
To disable all the WARNING SIGNAL :
- Disconnect the Interface cable of the monitor (Monitor is ON.).
- Press OSD button " " for over 15 seconds to disable all the
WARNING SIGNAL. Then release the "OSD" button.
- If it is successful, then the signal "
enter power saving-off mode.
To enable all the WARNING SIGNAL :
- After disconnect the Interface cable of the monitor, then Monitor is
powered ON.
- If it is successful, the signal "
NO SIGNAL INPUT
again later.
Back
OSD Lock Function & Service Mode
"disappeared to
NO SIGNAL INPUT
" comes on the screen
Access Service mode (burn in mode) :
Access Service Mode & Burn in mode
Firstly, get into Factory Adjustment Mode.
Push LEFT & RIGHT
over 15 seconds and release them.
The factory message appears at the bottom of the
main OSD menu. (for example : 109P V3.08 000601;
M.T.B.F. in HOUR unit)
00105 is
109P V3.08 000601
Disconnect the Interface cable of the monitor.
-
- Push LEFT & RIGHT
ON.
- If it is successful, the signal "
comes on the screen later.
(Background is white.).
Exit "burn in MODE" :
- Reconnect the interface cable to PC, then the "burn in MODE"
Disappear.
buttons at the same time for
00105
buttons at the same time, then power
"
SERVICE MODE
SERIAL NO: TY 123456
HOURS : 00021
FACTORY VER 1.01 990706
Forward