Advertisement
LOCK Button: Push this button to lock in all the current
12
settings. To release settings, push again. (Use a φ1mm little
round stick to push this button )
POWERFUL Button: Press this button on cooling/heating mode
13
to go into powerful cooling (heating)operation.Press again to
cancel it.
Note: The unit will automatically revert back to the previous
operational mode after continuously operating under the
powerful cooling mode.
Names and Functions of indicators on Remote Controller
Display Panel
1
2
4
6
TIMER ON/ OFF
7
Fig. 2
DIGITAL DISPLAY area: This area will show the temperature
1
and, if in the TIMER mode, will show the ON and OFF settings
of the TIMER. It will automatically revert back to show the
temperature after 5 seconds. Under "FAN" operation mode,
nothing is shown in this area.
TRANSMISSION Indicator: This indicator flashes once when
2
remote controller transmits signals to the indoor unit.
ON/OFF Indicator: This symbol appears when the unit is turned
3
on by the remote controller, and disappears when the unit is
turned off.
OPERATION MODE Indicator: Shows the current operation
4
modes--"AUTO", "COOL", "DRY", "HEAT" and "FAN".
HEAT only available for heat pump model.
3
FAN SPEED Indicator: Press the FAN SPEED button to select
5
the desired fan speed setting (Auto-Low-Med-High). You selection
will be displayed in the LCD window except the Auto fan speed.
LOCK Indicator: This symbol appears when press the LOCK
6
button, and disappears when press it again.
TIMER ON/OFF Display: This display area shows the settings
7
of TIMER. That is, if only the starting time of operation is set, it
will display the TIMER ON. If only the turning off time of operation
is set, it will display the TIMER OFF. If both operations are set,
it will show TIMER ON/ OFF which indicates you have chosen
to set both the starting time and off time.
!
NOTE: All signs shown in the Fig.2 is for the purpose of clear
presentation. But during the actual operation only the re-
lative functional items are shown on the display panel.
3
Operating the Remote Controller
4
5
Install/Replace Batteries
The Remote Controller uses two alkaline dry batteries
1. To install the batteries, slide the back cover of the battery
compartment and install the batteries according the
direction (+and -)shown on the Remote Controller.
2. To replace the old batteries, use the same method as
mentioned above.
AUTOMATIC OPERATION
When the Air Conditioner is ready for use, switch on the
power and the OPERATION indicator lamp on the display panel
of the indoor unit starts flashing.
1. Use the MODE .select button to select AUTO.
2. Push the TEMP button to set the desired room temperature.
The most comfortable temperature setting are between 21 C
o
to 28 C.
3. Push the ON/OFF button to start the air conditioner. The OPE-
RATION lamp on the display panel of the indoor unit lights. The
operating mode is AUTO FAN SPEED is automatically set
and there are no indicators shown on the display panel of the
remote controller.
4. Push the ON/OFF button again to stop the unit operation.
(LR03X2).
。
4
Advertisement
