Advertisement
Remote Controller Specifications
Model
R51D/E，R51D/CE
Rated Voltage
3.0V(Alkaline dry batteries LR03×2)
Lowest Voltage of CPU
2.0V
Emitting Signal
Reaching Distance
8m (when using 3.0 voltage,
Signal Range
it Gets 11m)
。
。
Environment
-5 C 60 C
~
Introduction of Function Buttons on the Remote Controller
1
O
SET TEMPERATURE（ C)
4
AUTO
FAN
COOL
HIGH
DRY
MED
HEAT
LOW
TEMP.
5
ON/OFF FAN SPEED
MODE
SWING ECONOMIC TIMER ON
RESET LOCK TIMER OFF
AIR DIRECTION
POWERFUL
6
7
Fig. 1
1
TIMER Operation
TIMER ON button can set the auto-on time of the unit.. TIMER
OFF button can set the auto-off time of the unit.
1. To set the starting time.
1.1 Push the TIMER ON button, then the remote controller shows
TIMER ON , the last set time for the starting operation and the
signal "h" will be shown on the DIGITAL DISPLAY area. You
are now ready to reset the time to START the operation.
1.2 Push the TIMER ON button again to set desired unit start
time.
1.3 After setting the TIMER ON ,there will be a one-half second
delay before the remote controller transmits the signal to
the air conditioner. Then, after approximately another 2
seconds, the signal "h" disappears and the set temperature
will re-appear on the digital display.
2
2. To set the stopping time.
8
2.1 Push the TIMER OFF button and the remote controller will
show TIMER OFF, the last set time for the stopping operation
3
and the signal "h" will be shown on the DIGITAL DISPLAY area.
You are now ready to reset the time of the STOP operation.
2.2 Push the TIMER OFF button again to set the time you want to
9
stop the operation.
2.3 After setting the TIMER OFF ,there will be a one-half second
delay before the remote controller transmits the signal to
10
the air conditioner. Then, after approximately another 2
seconds, the signal "h" disappears and the set temperature
11
will re-appear on the digital display.
3. Set the starting & stopping time
12
3.1 Push the TIMER ON button, the remote controller will show
TIMER ON, the last set time for START operation and
13
the signal "h" will be shown on the DIGITAL display area. You
are now ready to readjust the TIMER ON to start the operation.
3.2 Push the TIMER ON button again to set the time you want to
start the operation.
3.3 Push the TIMER OFF button, the remote controller will show
TIMER OFF, the last set time for STOP operation and
the signal "h" will be shown on the DIGITAL display area. You
are now ready to reset the time to STOP operation.
3.4 Push the TIMER OFF button again to set the time you want to
stop the operation.
6
Advertisement
