Advertisement
Names and Functions of indicators on Remote Controller
Display Panel
TRANSMISSION Indicator:
1
This indicator lights when remote
controller transmits signals to indoor unit.
Auto
MODE indicator:
2
Displays the current operation modes.
SET TEMP
Including AUTO(
HEAT( ) or FAN( ).
HEAT only available for heat pump model.
TEMPERATURE indicator:
3
Turbo
Displays the temperature settings(17
FAN SPEED indicator:
4
Displays the selected fan speed, AUTO( ) and
ON TIMER
three fan speed levels LOW(
Hr.
HIGH(
Off TIMER
operating mode is either AUTO or DRY .
Hr.
5
SLEEP/TURBO indicator:
Each time the Sleep/Turbo button is pushed, the
signal displays in the following sequence:
Fig. 2
Nothing appears when the operating mode is either
DRY or FAN only
SWING indicator:
6
This indicator lights up when the SWING
button is pressed.
TIMER indicator:
7
The time set for timer operation is indicated.
(0.5 ~ 24 hours)
NOTE: All items are shown in the Fig.2 for the purpose of clear
presentation But during the actual operation only the
relative functional items are shown on the display panel.
), COOL( ), DRY( ) ,
Auto
to 30 ).
), MED(
),
). Displays
when the
(flashing)
Nothing
Nothing
Turbo
3
Operating the Remote Controller
Install / Replace Batteries
Use two alkaline dry batteries (R03/LR03X2).
Do not use rechargeable batteries.
(1) Remove the battery cover by pulling it according to the
arrow direction.
(2) Insert new batteries making sure that the
(+) and (-) of battery are installed correctly.
(3) Reattach the cover by sliding it back into position.
NOTE
1. When replacing batteries, do not use old batteries or a different
type battery. This may cause the remote controller to
malfunction.
2. If you do not use the remote controller for several weeks
remove the batteries. Otherwise battery leakage may damage
the remote controller.
3. The average battery life under normal use is about 6 months.
4. Replace the batteries when there is no answering beep from the
indoor unit or if the Transmission Indicator light fails to appear.
AUTOMATIC OPERATION
When the Air Conditioner is ready for use, switch on the power
and the OPERATION indicator lamp on the display panel of the
indoor unit starts flashing.
1. Use the Mode select button to select AUTO.
2. Push the
or
button to set the desired room temperature.
The most comfortable temperature settings are between 21 C
to 28 C.
3. Push the On/off button to start the air conditioner. The OPE-
RATION lamp on the display panel of the indoor unit lights. The
operating mode is AUTO. The FAN SPEED is automatically
controlled.
4. Push the On/off button again to stop the unit operation.
NOTE
1. In the AUTO mode, the air conditioner can logically choose
the mode of COOL, FAN, HEAT and DRY by s ensing the dif-
ference between the actual ambient room temperature and
the set temperature on the remote controller.
2. If the AUTO mode is not comfortable for you , the desired mode
can be selected manually.
4
Advertisement
