AUSTRALIAN MONITOR XRS12P Installation And Operaion Manual

AUSTRALIAN MONITOR XRS12P Installation And Operaion Manual

Advertisement

SERVICE INFORMATION

POWERED LOUDSPEAKER
CONTENTS:
OPERATION MANUAL
SCHEMATIC DIAGRAM
1 Clyde Street, Silverwater NSW 2128 Australia
www.australianmonitor.com.au
XRS12P
Australian Monitor
+61 2 9647 1411

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the XRS12P and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for AUSTRALIAN MONITOR XRS12P

  • Page 1: Service Information

    SERVICE INFORMATION XRS12P POWERED LOUDSPEAKER CONTENTS: OPERATION MANUAL SCHEMATIC DIAGRAM Australian Monitor 1 Clyde Street, Silverwater NSW 2128 Australia +61 2 9647 1411 www.australianmonitor.com.au...
  • Page 2 XRS SERIES POWERED AND PASSIVE LOUDSPEAKERS INSTALLATION AND OPERATION MANUAL...
  • Page 3: Important Safety Information

    Do not parallel- or series-connect an amplifi er output with any other amplifi er output. Australian Monitor is not responsible 7. Always operate the unit with the AC ground wire connected to the for damage to loudspeakers for any reason.
  • Page 4: Introduction And Contents

    Building on the reliability and sonic quality of the very popular XR speaker INTRODUCTION series, Australian Monitor brings you the AM Pro XRS two way injection moulded speaker enclosures with more features and new aesthetic to suit both live FRONT AND REAR PASSIVE PANEL sound reinforcement and permanent installation.
  • Page 5 The XRS10 and XRS12 have 2 connectors. They XRS10/XRS10P 1.5” are wired in parallel so either connector can be used as an XRS12/XRS12P 2” input, the other as a loop through. Active crossover and power amp in XRS8P/10P/12P.
  • Page 6 HRC 20mm x 5mm ceramic or glass type fuse. This is a red LED clip indicator for the mixed mic and line audio signal. Some XRS8P XRS10P XRS12P fl ashing of red is acceptable on program 2.5A 2.5A 5.0A transients. Continuous fl ashing of red could be placing undue stress on the speaker and will sound distorted.
  • Page 7: Specifications

    SPECIFICATIONS XRS8P XRS10P XRS12P Drivers 1 x 8” woofer 1 x 10” woofer 1 x 12” woofer 1 x 1.5” HF driver 1 x 1.5” HF driver 1 x 2” HF driver Frequency Response(-3dB) 65Hz-18kHz 55Hz-18kHz 50Hz-18kHz Frequency Response(-10dB) 55Hz-18kHz...
  • Page 8 SPECIFICATIONS XRS8 XRS10 XRS12 Drivers 1 x 8” woofer 1 x 10” woofer 1 x 12” woofer 1 x 1.5” HF driver 1 x 1.5” HF driver 1 x 2” HF driver Frequency Response(-3dB) 65Hz-18kHz 55Hz-18kHz 50Hz-18kHz Frequency Response(-10dB) 60Hz-20kHz 50Hz-20kHz 40Hz-20kHz Sensitivity(dB 1W 1m)
  • Page 9: Australia And New Zealand

    AUSTRALIA AND NEW ZEALAND www.australianmonitor.com.au SYDNEY MELBOURNE ADELAIDE AUCKLAND (NSW SALES) (VIC & TAS SALES) (SA & NT SALES) (NZ SALES) 1 Clyde Street 22/277 31 Walsh Street 9C Piermark Drive Silverwater Middleborough Road Thebarton Albany 0752 NSW 2128 Box Hill VIC 3128 SA 5031 New Zealand Private Bag 149...
  • Page 10 -15V +15V IC3C IC2C IC1C LED3 2N5401 -15V -15V 10U/25V-NP 100K 5P*100MM(2.5MM) 6P*100MM(2.5MM) JRC4560 100U/50V +15V +15V 10U/25V-NP JRC4560 JRC4560 JRC4560 10PIN2.54mm 10PIN2.54mm -15V +15V +15V +15V IC4C LED2 JRC4560 GREE 1N4148 150K -15V -15V 2N5551 IN4148 Australian Monitor XRS12P...

Table of Contents