Radio Mode - Caliber MCD771 Operation Instructions Manual

Radio Mode

Accessing Radio Mode
Press the SRC button on the front panel or
remote control to switch to the Radio source.
1
4
5
6
7
8
Selecting a Band
Press BAND once or more to select FM1-
FM2 - FM3 - MW1 - MW2.
Display shows wave band, frequency, and
preset station number if already stored.
Selecting a Station
Press the or
another station.
Tuning
- AUTO SEEK
Press the or buttons to seek the next/
previous station automatically.
- MANUAL SEEK
Press and hold the
manual tuning mode. Press the buttons again
to move the radio frequency number up or
down one step.
Note:
During manual seeking, if the pause between
two operating steps is longer than 5 seconds,
press the or buttons, the unit will enter
auto seeking.
Preset Mode
Six numbered preset buttons store and recall
stations for each band. The stored stations
(P1-P6) for the current band can be viewed on
the screen.
2
tuning button to tune to
or buttons to enter
3
1. Source Indicator
2. Current Preset Channels
3. Time/Clock
4. AM/FM Band
5. RDS Information
6. Radio Station Frequency
7. EQ Indicator
8. AF Indicator
Storing Stations
- Auto storing
1. Select a band (if needed).
2. Press AMS briefly to scan the preset station
P1 - P6 for 5 seconds each.
3. Hold AMS more than 2 seconds, the
6 strongest available stations will be
automatically saved in the preset button
(numbers 1-6).
- Manual Storing
1. Select a band (if needed), then select a
station.
2. Press and hold a preset button (numbers
1-6) on the front panel or remote control.
3. The preset number and station is displayed
and highlighted.
Recalling a Station
1. Select a band (if needed).
2. Press a front panel or remote control
preset button (numbers 1-6) to select the
corresponding stored station.
11