1, Precautions Before Starting Operation; 2, Specifications - HIGHLEAD GC22618 Instruction Manual Parts Catalog

1, PRECAUTIONS BEFORE STARTING OPERATION
1) Safety precautions
( 1) When turning the power on, keep your
bands
and :fingers away from the area around/under the needle
and the area around the pulley.
(2) Power must be turned off when the machine is not in use, or when the operator leaves the seat
(3) Power must be turned off when tilting the machine head, installing or removing the "V" belt, adjusting
the
machine, or when replacing.
(4)
Avoid placing fingers, hairs, bars etc., near the pulley, "V" belt, bobbin winder pulley, or motor when
the·rnachine is in operation.
(5)
Do not insert fingers into the thread take-up cover, under/around the needle, or pulley when the machine
is in operation.
( 6) If a belt cover, finger guard, eye guard are installed, do not operate the machine without these safety
devices.
2) Precautions before starting operation
(1) If the machine's oil pan has an oil sump, never operate the machine before filling it.
(2) If
the machine is lubricated by a drop oiled (consider revising), never operate the machine before
lubricating.
(3) When a new sewing machine is first turned on, verify the rotational direction of the pulley with the
power on. (The pulley should rotate counterclockwise when viewed from the pulley)
(4) Verify the voltage and (single or three) phase with those given on the machine nameplate.
3) Precautions for operating conditions
( 1) Avoid using the machine at abnormally high temperatures ( 3 5
'C
or higher) or low temperatures ( 5
'C
or
lower) .
(2) Avoid using the machine in dusty conditions.
2_, SPECIFICATIONS
Max. Sewing Speed
2200rpm
Max. Stitch Length Smm
Thread Take-up Lever Stroke 61.Smm
Needle Bar Stroke 33.4mm
Presser Foot Stroke By Hand 8mm
By Knee 14mm
Alternating Movement Lifting Presser Foot 4.3mm
Needle DPX 17
22#
Rotating Hook KRT31-11SG
Lubrication System Manual
Electric Machinery 1400rpm370W
- 1 -