Titan TI-7700 Instruction Manual page 19

Connect to the power supply, and turn the power switch to "—" position, the chair is now
in idle mode. During the idle mode, only five functions are available:" ON/OFF, Recline
Backrest, Raise Backrest, Elevate Leg rest, Recline Leg rest" and Pause.
CONTROL BUTTONS FOR THE MASSAGE CHAIR
1. ON/OFF
The Start/ Stop Control Button
Press once on this button to start the massage chair, the backrest is reclined
automatically for 3 seconds and the leg rest is elevated automatically for 5 seconds to
the specified position, and then press any massage function button to conduct
massage functions.
Press this button again to stop all massage functions and the massage rollers return to
original position.
Note: You can adjust angle of backrest and leg rest further to desired position.
2. Timer
Time Interval Control Button
When a massage function is activated the time is automatically set for 15-minute.
Every time this button is pressed, the time interval will change in the following
sequence:
20>25>30>5>10>15- minutes
Note: The backlight of the remote controller will automatically light up followed by five
beeps when one minute remains on the timer.
3. Zero-G
Press this button once to active the Zero-G1 function.
Press the button again to active the Zero-G2 function.
Press the button the third time to stop the Zero-G function.
Note: If the button is pressed in the process of the chair moving to zero-G1 or Zero-G2
position, the massage chair will confirm the position before getting the preset Zero-G1
or Zero-G2 position.
4. Pause
Press this button once to stop all massage functions and pause the chair to idle mode.
Press the button again to resume the original massage function.
18