Dali LT7-P User Manual page 10

LT3-P/LT7-P Thermal Image Camera User Manual
[1] Power key
Press and hold the Power Key for > 3 seconds to power on/off the camera.
! Note: After powering off, please wait ten seconds before powering the
camera on again.
[2] Select/Auto key (Marked "A")
The "A" or attribute button performs 2 functions.
a) The first function is modification of selected parameters. It is obtained
by a quick press and release (less than 2 seconds), with this functions to
modify their parameters.
available parameters. The selected function will be highlighted in yellow. The
functions include:

Measurement points, areas, and lines
Cursors and lines - pressing the arrow keys will move their position.
Pressing the Menu key will pop up the attribute box. Pressing the C key will
delete the selected parameter.
Areas – Arrow keys adjust the attribute specified in the pop up attribute
box. Pressing the Menu key will pop up the attribute box. In this box, the user
can select to adjust either position or size of the area. After selection, the
arrows will then adjust the attribute.

Color Palette
Pressing the left or right arrows will scroll through the available color
palettes, displaying their name above the palette. The selected palette will
become active after about 3 seconds of selecting it and will be set as the
default power on palette.

Level/Span values
Pressing the left or right arrow will reduce or increase the Span and
pressing the up or down arrow will reduce or increase the Level. If the unit is
in Automatic mode, modifying any of these parameters will select Manual
mode.
b）The second function performed is to force an internal calibration cycle.
Subsequent presses will "scroll" through the
10
DALI