Installing The Batteries; Charging Your Hopper-Fly - MegaTech Hopper fly Manual

INSTALLING THE BATTERIES

5
CHARGING BASE
• Using a Philips Head screwdriver,
unscrew the battery hatch.
• Paying close attention to their polarity (+
and -) install 8 C-size alkaline batteries.
NOTE: If your batteries are not installed
properly the charging base will not function
• Reattach the battery hatch and securely
tighten the screws.
RADIO CONTROL
• Remove the battery hatch using the tip
of a ball point pen to push in the button
located at the top of the battery door
• Install 9V battery paying careful attention
to the polarity.
NOTE: If the 9V battery is not installed
properly your transmitter will not function
• Reattach battery hatch using the tip of a ball point pen to push the hatch button in
as you slide on the hatch

CHARGING YOUR HOPPER-FLY

Your Hopper-Fly features built-in Megatech extended run time high performance
rechargeable NiMh (Nickel-Metal Hydride) battery that must be charged before each fl ight
(approximately 4-6 minutes charging time). NiMh Technology indicates that batteries improve
performance the more you use them. The base is equipped with an automatic timer charger.
It will automatically shut off when the battery is charged. The approximate charge time is 4-6
minutes. NOTE: Never charge for more than 10 minutes or leave unattended while charging.
SWITCH IS IN OFF PLUGGING IN THE CHARGER LIGHT
POSITION CHARGER LINK SHOWS CHARGING IN
PROGRESS