Removing A Memory Module - Toshiba Satellite Pro R50-C User Manual

8.
Ensure that the memory module cover is firmly closed.
9.
10. Turn your computer over.
11. Connect the AC adaptor and turn on the computer. Make sure that the

Removing a memory module

To remove the memory module, do the following:
1.
2.
3.
4.
5.
6.
7.
User's Manual
Align the grooves along the edges of the memory module with the
locking tabs on the connector and insert the module into the connector
firmly. If you find it difficult to install the memory module, gently prise
the locking tabs outwards using the tip of your finger.
Also ensure that you hold the memory module along its left and right
hand edges - the edges with the grooves in.
Seat the memory module cover in place and secure it with the screw.
Figure 4-9 Seating the memory module cover
1. Memory module cover
Install the battery pack.
added memory is recognized. To confirmed it, click Start -> Control
Panel -> System and Security -> System.
Click Start. Point to the arrow (
then click Shut down. Ensure that the Power indicator is off.
Remove the AC adaptor, all cables, and peripherals connected to the
computer.
Close the display panel.
Turn the computer upside down and remove the battery pack.
Loosen the screw securing the memory module cover in place. Note
that the screw is attached to the cover in order to prevent it from being
lost.
Slide your fingernail or a thin object under the cover and lift it off.
Push the latches away from the module in order to release it. A spring
forces one end of the module up at an angle.
2
2. Screw
) beside the Shut down button and
1
4-25