Kobalt K18ND-06A Manual page 29

OPERATING INSTRUCTIONS
CUTTING WITH THE CIRCULAR SAW
5HIHU WR WKH ¿JXUHV LQ WKLV VHFWLRQ WR OHDUQ WKH FRUUHFW
and incorrect ways of handling the saw.
WARNING: To make sawing easier and safer, always
maintain proper control of the saw. Loss of control could
FDXVH DQ DFFLGHQW UHVXOWLQJ LQ VHULRXV LQMXU\
DANGER: When lifting the saw from the workpiece,
the blade is exposed on the underside of the saw until
the lower blade guard closes. Make sure that the lower
blade guard is closed before setting the saw down.
To make the safest and best possible cut, follow these
helpful hints:
 +ROG WKH VDZ ¿UPO\ ZLWK ERWK KDQGV
2. Avoid placing your hand on the workpiece while making
a cut (Fig. 9).
3. Support the workpiece so that the cut is always to
the operator's side and not directly in line with the
operator's body.
4. Support the workpiece near the cut.
5. Clamp the workpiece securely so that the workpiece
will not move during the cut (Fig. 10).
6. Always place the saw on the portion of the
workpiece that is supported, and not on the "cut off "
piece (Fig. 11).
7. Place the workpiece with the "good" side down.
8. Draw a guideline along the desired cutting line before
beginning the cut.
9 9
0
10
11
29