fitness gear 810E User Manual page 6

A S SE MB LY ST E P 
STEPS A-E
PRE-INSTALLED
BOLT & WASHER
RESISTANCE TOP KEY HOLE
KNOB
BOTTOM KEY HOLE
TENSION WIRE RESISTANCE
KNOB BRACKET
NOTE: There is NO hardware bag for this step. All hardware is pre-installed.
A) Pull TENSION cABLE out from square hole in console mast.
B) Turn RESISTANcE KNOB to highest resistance setting. Place the TENSION WIRE into the BOTTOM KEY HOLE
on the RESISTANcE KNOB BRAcKET.
C) While holding the RESISTANcE KNOB BRAcKET, pull the RESISTANcE KNOB up to slide it into the TOP KEY
HOLE position on the RESISTANcE KNOB BRAcKET.
D) Once the TENSION WIRE is in position, turn the RESISTANcE KNOB to the lowest resistance setting.
E) Slide RESISTANcE KNOB & BRAcKET into the cONSOLE MAST and attach using PRE-INSTALLED BOLT &
WASHER.
F) Remove PRE-ATTAcHED BOLT & WASHERS from cONSOLE MAST.
G) Slide LOWER HANDLEBARS onto cONSOLE MAST and attach by re-inserting PRE-ATTAcHED SET ScREWS.
H) Slide UPPER HANDLEBARS onto LOWER HANDLEBARS. Secure UPPER HANDLEBARS to LOWER HANDLEBARS
using PRE-ATTAcHED SET ScREWS.
After handlebars are assembled they will rotate freely – be cautious. Until the
machine is fully assembled, do not grab the handlebars for support.
10
STEPS F-H
UPPER HANDLEBAR
PRE-ATTACHED SET SCREWS
PRE-ATTACHED BOLTS AND WASHERS
TENSION
LOWER HANDLEBAR
CABLE
ASSEMBLY STEP 
HANDLEBAR
COVERS
NOTE: There is NO hardware bag for this step.
A) Attach WIRES from mast to handlebar. DO NOT PINcH WIRES.
B) Snap the front and back HANDLEBAR cOVERS together onto the UPPER HANDLE BARS.
Note the position of the snap tabs on the covers before snapping into position.
C) Repeat on other side.
11