fitness gear 810E User Manual page 5

A S SE MB LY S T E P 2
BOLT (D)
REAR
WHEEL
TRACKS
A) Open HARDWARE BAG FOR STEP 2.
B) Attach the REAR WHEEL TRAcKS to the MAIN FRAME using BOLTS (A) and 2 WASHERS (B) from the front.
Then finish securing the REAR WHEEL TRAcKS to the MAIN FRAME using 2 BOLTS (D), 2 NUTS (F) and
2 WASHERS (B) from the top.
C) Attach PEDAL ARM cOVERS to PEDAL ARMS using ScREWS (c).
HARDWARE BAG FOR STEP 2 CONTENTS :
BOLT (A)
70 mm
Qty: 2
SCREW (C)
Qty: 2
8
MAIN FRAME
PEDAL ARM COVER
SCREW (C)
WASHER (B)
BOLT (A)
NUTS (F)
WASHER (B)
17 mm
Qty: 4
BOLT (D) NUT (F)
55 mm Qty: 2
Qty: 2
ASSEMBLY STEP 
PRE ATTACHED SCREWS
WATER BOTTLE CAGE
CONSOLE MAST
NUTS (F)
TOP CAP
A) Open HARDWARE BAG FOR STEP 3.
B) Slide the TOP cAP over the cONSOLE MAST. Attach WATER BOTTLE cAGE using PRE ATTAcHED ScREWS.
C) Attach the cONSOLE MAST to the MAIN FRAME using BOLT (A), SPRING WASHER (D) and WASHER (B) from
the front and 2 BOLTS (E), 2 WASHERS (B) and 2 NUTS (F) from the side. Make sure to pull the WIRE
through the cONSOLE MAST.
D) Snap TOP cAP into place.
HARDWARE BAG FOR STEP  CONTENTS :
BOLT (A) SPRING WASHER (D)
15 mm
20 mm
Qty: 1 Qty: 1
BOLT (E)
55 mm
Qty: 2
CONSOLE MAST
BOLT (A)
SPRING WASHER (D)
WASHER (B)
WASHERS (B)
BOLTS (E)
MAIN FRAME
WASHER (B)
17 mm
Qty: 3
NUT (F)
Qty: 2