Connecting The Soundbar And Subwoofer Manually; Adjusting The Volume; Equaliser Setting - Medion P69099 Instruction Manual

6.3. Connecting the Soundbar and subwoofer
manually
 The unit must be in standby mode.
 Press and hold the PA I R button on the rear of the subwoofer for a few
seconds. The subwoofer will switch to pairing mode and the Pair-LED will blink
quickly.
 Press the S TA N D B Y button on the top of the Soundbar or the S TA N D B Y
button on the remote control to switch the units on.
 After the wireless connection succeeded, the Pair-LED will light up.
 If the Pair-LED blinks, the wireless connection has failed. Unplug the cable of
the subwoofer and then reconnect the main cable. Repeat the steps above
afterwards.
NOTE
If the attempt to connect the units fails again, clear the area around the
units of any potential sources of interference (mobile telephones, etc.)
and then repeat the steps listed above.

6.4. Adjusting the volume

Use the + / – buttons on the Soundbar or on the remote control to adjust the
volume to the required level:
V O L + :
• Increase volume
V O L - :
• Reduce volume
The volume can be turned off completely by pressing the M U T E button on the
remote control.
 Press the M U T E button again to restore the sound.

6.5. Equaliser Setting

While playing, you can press the E Q button on the remote repeatedly to select
between the following preset equalisers:
Movie: recommended for viewing movies (MOVIE/MUSIC-LED lights up)
Music: recommended for listening to music (MOVIE/MUSIC-LED blinks)
Default: EQ mode off (MOVIE/MUSIC-LED off )
NOTE
While using the OPTICAL or AUX connection, Movie EQ will be
automatically selected.
While using the MP3 LINK connection or in BLUETOOTH operation,
Music EQ will be automatically selected.
After Sales Support
Telephone:
20 of 24
Internet:
1300 884 987
www.medion.com.au