Sony SLV-D985P AZ Operating Instructions Manual page 16

To change the RF channel
If the picture does not appear clearly on the TV, change the RF channel on the DVD-
VCR and TV. Select "Install" in the "OPTION" menu, then press V/v to select
"Video Output CH." Select the RF channel by pressing the B/b buttons and press
ENTER. Then, tune the TV to the new RF channel so that a clear picture appears.
Tip
• If you want to change the language for the on-screen display from the one preset in the Auto
Set Up function, see page 17.
Notes
• Whenever you operate the Auto Set Up function, some of the settings (timer etc.) will be
reset. If this happens, you have to set them again.
• Auto preset starts automatically only when you plug in the mains lead for the first time after
you purchase the DVD-VCR.
• If you want to use the Auto Set Up function again, select "Install" in the "OPTION" menu,
then press V/v to select "Auto Setup," then repeat step 3.
• Auto preset can be performed by pressing x on the unit continuously for 5 seconds or more
during power off with no tape inserted.
• The Line Through function will not operate properly if "Power Save" in "OPTION" menu is
set to "On." Set "Power Save" to "Off" to ensure proper operation.
16
Setting up the DVD-VCR with the Auto Set Up function