Advertisement
GPRS Network Settings
1. Login to the RER601/603 Configurator (for instructions, see page 2).
2. Navigate to Network page
3. Set access point name appropriately (usually INTERNET).
4. Set GPRS network username and password
authentication. Enable "Default Route" setting.
5. Optionally set the PIN code, PPP idle timeout and ICMP Echo settings (Network-->Monitor
menu) to meet your requirements.
If your SIM card has PIN code set, type the code to the PIN code field.
•
PPP idle timeout defines the time in seconds how ofter the RER601/603 resets the GPRS
•
connection if the connection is idle.
1. Finally click Apply and then Commit
2. Reboot the RER601/603 for the settings to take effect.
1
2
5
Using the RER601/603 as Wireless Access Point
1. Set your Ethernet device to use the IP address of the RER601/603 as its default gateway.
2. Configure your Ethernet device to be in the same network as the RER601/603.
3. Check GPRS Settings. Note that "Default Route" needs to be enabled in GPRS settings.
Final words
It is highly recommended that the product's Technical Manual be used as reference for optimal
use of this device.
ABB
Wireless Gateway RER601/603
Quick Start Guide
and from there navigate to GPRS subpage.
1
Figure 3: GPRS Network Settings
www.abb.com/substationautomation
appropriately if your GPRS service requires
4
to store the settings.
5
2
3
4(4)
3
4
1MRS757426 Rev. A
Advertisement
