Advertisement
Method 2: Using serial console
1. Switch off the RER601/603 if necessary
2. Connect a null modem serial cable to console serial connector (RS1)
3. Open a terminal connection to the RER601/603 using the following serial communication
settings: 19200-8-N-1, no flow control.
4. Switch on the RER601/603 by turning the power switch to ON position
5. Wait for the text "Hit any key to stop autoboot" and press enter before the counter
goes to zero. If you missed it, just reboot and try again.
6. You are now supposed to be on the PPCBoot console. Figure 2 shows how it looks like.
7. Now enter the following commands to the console, parameter fields substituted with your
parameters (see figure 2 for example):
setenv ipaddr your_IP_address
setenv netmask your_netmask
setenv gatewayip 0 (By default, GPRS or SSH-VPN is defined as default Gateway)
8. Check that the configuration was entered properly by issuing command printenv.
9. If everything is correct, save the setting with command savenv.
10.Reboot the RER601/603 for the settings to take effect.
.
.
.
DRAM:
32 MB
FLASH:
8 MB
In:
serial
Out:
serial
Err:
serial
Net:
00:06:70:01:02:23
Hit any key to stop autoboot:
abbrer> setenv ipaddr 192.168.0.50
abbrer> setenv netmask 255.255.0.0
abbrer> setenv gatewayip 0
abbrer> printenv
baudrate=19200
loadaddr=0x20000
...
ipaddr=192.168.0.50
netmask=255.255.0.0
gatewayip=0
Environment size: 407/4092 bytes
Disabling watchdog
abbrer> savenv
Saving Enviroment to EEPROM...
abbrer>
Figure 2. Network parameter configuration using serial console
ABB
Wireless Gateway RER601/603
Quick Start Guide
0
www.abb.com/substationautomation
3(4)
1MRS757426 Rev. A
Advertisement
