Assembling The Smartscoot Tm - IMP SmartScoot User Instruction Manual

ASSEMBLING THE SMARTSCOOT™
CONNECTING THE REAR WHEELS
The rear wheels adjust to three different positions offering the user additional stability when
using the SmartScoot™. The wider the wheel base, the more stable the scooter will be during
use.
PLEASE NOTE – Even though the wider wheel base offers more stability, it also makes it
more difficult to go through doorways. We recommend the middle setting.
1. Loosen the clamps at both ends of the rear axle by lifting up the levers on the clamps.
2. Remove the metal tubes protruding from the ends of the rear axle and discard them
(these were used to protect the axle during shipping).
3. Insert the rear wheel with tubing into the opening of the rear axle until the hole of the tubing
aligns with one of the three holes on the rear axle. The first hole is for the widest setting, the
middle hole is for the medium setting and the third hole is for the narrowest setting.
4. Holding the button on the adjusting pin, slide the pin through the holes of the tubing and
rear axle. Make sure to hold the button until the pin goes through both holes (front and
back).
5. PLEASE NOTE – The wheels must be at the same width setting on both sides. For
example, the middle position on left means you have to be in the middle position on
the right.
6. Tighten the clamp by pushing down on the lever.
7. Repeat on the other side
WARNING – Prior to driving make sure that each side is in the same position, that the
alignment pins are through both holes and that the clamps are tightened and secured.
8