IMP SmartScoot User Instruction Manual page 12

1. Remove the seat from the SmartScoot™ by
removing both pins from the seat post, releasing
the lever which loosens the clamp.
2. Once the optimal seat height is determined, insert
one of the adjusting pins into the hole by pressing
on the small knob and pushing it through both
holes of the attached seat post. Replace the seat
onto the scooter.
3. Push in the lever which will tighten the clamp. If the
clamp does not tighten, turn the lever on the left while
holding the screw on the right. This tightens
the locking system. Grab hold of the lever and pull it
forward until it tightens. PLEASE NOTE –
Over tightening the screw will make it
difficult for you to tighten the handle. You
might have to loosen the screw to adjust
tension. The system requires that you use
some force to tighten the latch.
4. Replace the locking pin into the top hole. Press
down the small knob on the pin until the pin is
through both holes in the post.
SEAT SECURITY
To ensure seat security while driving or lifting the SmartScoot™ the seat must be
securely attached to the unit. There are two steps required to ensuring seat security.
1. Tighten the clamp by pushing in the lever.
2. Insert the security pin into the top hole of the scooter.
12