Connecting The Battery - IMP SmartScoot User Instruction Manual

CONNECTING THE BATTERY

1. With the SmartScoot™ label facing on top and
the battery label facing on the left side,
carefully align and slide the battery pack
downward making sure that it slides into place
2. Twist the top latch to secure the battery.
3. Insert the battery cord from the control panel box
into the battery socket.
4. Turn the switch on the control panel box to the on
position.
POSITIONING AND TIGHTENING THE BRAKE HANDLE
1. This process requires you to use the enclosed
Allen wrench.
2. Sitting on the scooter, place your right hand on
the throttle.
3. Next, lift the hand brake to a comfortable position
on the handlebars. The recommended position is
just below level from the throttle
4. Slide the Allen wrench into the bolt and
tighten to secure.
FOOT RESTS
1. Pull down foot rests.
LED HEADLIGHT
1
. The headlight is to be mounted on the handlebar and is operated independent of
the throttle controls. The headlight should be used in dark conditions. Pressing
the top of the headlight turns on the headlight and also changes its mode from
flashing quickly, to flashing slowly, to on, to off. The "light" button on the control
panel does not control this headlight.
10
Battery Socket