Prepare The Remote Control; Demonstrate The Features; Power On - Philips btm3360 User Manual

Connect the power cable to the wall socket.

Prepare the remote control

Caution
•
Risk of product damage! When the remote control is
not used for long periods, remove the batteries.
To insert the remote control battery:
1
Open the battery compartment.
2
Insert the supplied AAA battery with
correct polarity (+/-) as indicated.
3
Close the battery compartment.

Demonstrate the features

In standby mode, press
features of this device.
» The features are displayed one by one
across the display panel.
• To turn off the demonstration, press
again.

Power on

Press .
» The product switches to the last selected
source.
10 EN
to demonstrate
Switch to standby mode
Press again to switch the product to standby
mode.
» The clock (if set) is displayed on the
panel.
• In standby mode, press
between working mode and standby
mode.
Note
•
The product switches to standby mode after 15
minutes inactive.
Switch to ECO power standby mode
Press and hold for more than two seconds.
» The red ECO power standby indicator
turns on.
• In Eco power standby mode, press
switch between working mode and ECO
power standby mode.
Note
•
The product switches to ECO power standby mode
after 15 minutes in standby mode.
Switch between standby mode and ECO
powerstandby mode:
• Press and hold
seconds.
Note
•
If no button is pressed over 15 minutes in standby
mode, this product goes to ECO standby mode
automatically.
to switch
to
for more than two