Philips sc1996 User Manual page 23

Model SC1996
Rated voltage
Rated frequency
Rated input
Protection against electric shock
Protection rating
Operating conditions
Storage conditions
Spectrum of body attachment
Spectrum of precision attachment
Problem Possible cause
The adapter/ This is normal.
appliance becomes
warm during
charging.
I have switched on The appliance
the appliance but I has to be reset.
cannot increase or
decrease the light
intensity.
The 'ready to flash' You have not
light does not properly placed
work when I place the appliance on
the appliance on the skin.
the skin.
Technical specifications
Troubleshooting
This chapter summarises the most common problems you could
encounter with the appliance. If you are unable to solve the problem with
the information below, visit www.philips.com/support for a list of
frequently asked questions or contact the Consumer Care Centre in
your country.
Solution
No action required.
To reset the appliance, switch off the appliance and
then switch it on again. If you still cannot adjust the light
intensity, contact the Consumer Care Centre in your country,
your Philips dealer or a Philips service centre.
Place the appliance at a 90° angle onto the skin in such a
way that all 4 sides of the integrated safety system touch
the skin. Then check if the 'ready to flash' light lights up white
continuously and press the flash button.
100V-240V
50Hz-60Hz
36W
Class II Q
IP 30 (EN 60529)
Temperature: +15° to +35°C
Relative humidity: 30% to 95%
Temperature: -20°C to +70°C
Relative humidity: 5% to 95%
>500nm
>600nm
ENGLISH
23