Advertisement
3.2. SPECIFICATION
Manifold Pressure . . . . . . . . . . . . . . . . 87bar
Max Pressure . . . . . . . . . . . . . . . . . . . 130bar
Effective Cleaning Pressure . . . . . . . 3200psi
Water Flow . . . . . . . . . . . . . . . . . . . . 380ltr/h
Motor Power . . . . . . . . . . . . . . . . . . . . 1600W
4.
SET UP
4.1
Connecting the high pressure hose. Remove and discard the transit plug from the water 'out' connector on the lower front of the
machine (see fig.1). Attach the high pressure hose as indicated in fig.2 ensuring that the connector is tight.
4.2
Connecting the water supply. Screw the hose connector to the water inlet on the machine (see fig.3). Use a reinforced hose pipe
with an internal diameter of 1/2" and connect to the mains water supply as indicated in fig.4.
Assembling the lance and nozzle. Insert the lance into the gun as shown in fig.5. Twist the lance through 90 ° until it clicks into
4.3
place. Turn on the water and check that all connections are water tight.
4.4
Safety catch. Familiarise yourself with the operation of the
safety catch. See diagram above and section 5.1.
5. OPERATION
WARNING! Ensure you read, understand and apply Section 1 safety instructions.
WARNING! Dry running can seriously damage the unit.
WARNING! DO NOT leave washer switched on for more than 15 minutes without operating trigger.
5.1
Operation of safety catch. To prevent inadvertant operation of the unit the safety catch should always be engaged when the gun is
not in use. To engage the catch push it upwards over the end of the trigger as shown in fig.7A. To release the catch press it
downwards and away from the trigger as indicated in fig.7B.
Important! The washer motor will stop as soon as the gun trigger is released and will restart when the trigger is squeezed.
Always allow at least 5 seconds between releasing the trigger and restarting.
Motor Type . . . . . . . . . . . . . . . . . . . .Induction
Input:
. . . . . . . . . . . . . . . . . . . . 230V - 7.8A
Rec. Power Supply. . . . . . . . . . . . . . . . . 13A
Motor Speed. . . . . . . . . . . . . . . . . . .2800rpm
Max. Inlet Temp . . . . . . . . . . . . . . . . . . . 50 ° C
4.5
Original Language Version
Total Stop . . . . . . . . . . . . . . . . . . . . . . . . . Yes
Hose Length . . . . . . . . . . . . . . . . . . . . . . 6mtr
Rotorblast Nozzle . . . . . . . . . . . . . . . . . . . Yes
Integral trolley. . . . . . . . . . . . . . . . . . . . . . Yes
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . 13kg
Rotorblast nozzle. The nozzle is non-adjustable. Do not
attempt to turn it or disassemble it or your warranty may be
void. Keep the nozzle 150 to 200mm from the surface being
cleaned.
PC2950.V5
Issue: 2 - 01/06/11
Advertisement
