Advertisement
5.8.
CONTROL PANEL
G
A2
F
A3
fig.4
Item
A1. Level 1# button
A2. Level 2# button
A3. Level 3# button
B1. Level 1 indicator
B2. Level 2 indicator
B3. Level 3 indicator
C. Water shortage warning indicator
D. Multi - function button
E. Running indicator
F. Holding pressure indicator
G. Over temperature warning indicator
6. OPERATION
p
‰
WARNING! Ensure you read, understand and apply Section 1 safety instructions.
‰
WARNING! Dry running can seriously damage the unit.
WARNING! Use washer on a flat, levelled surface, in an upright position. Failure to do so will invalidate your warranty. Never lay the
‰
washer down during use.
WARNING! DO NOT leave washer switched on for more than 15 minutes without operating trigger.
‰
IMPORTANT! The washer motor will stop as soon as the gun trigger is released and will restart when the trigger is squeezed. Always
allow at least 5 seconds between releasing the trigger and restarting.
6.1.
PRIMARY CHECKS
6.1.1.
Check that the inlet filter is clean; pump delivery and pressure will be reduced if blocked. Never use the machine without a filter (which
is fitted inside the inlet connector fig.1.9). Ensure that the water supply, high pressure hose and gun are correctly connected, and that air
can circulate around the washer freely.
© Jack Sealey Limited
A1
B1
B2
E
Function
1. Set working level button
2. Wireless pairing mode button (long press Level 1# button and Level 3#
button at the same time for 2 seconds).
3. Exit wireless pairing mode button ( long press one button for 2 seconds).
The indicator light shows the current level
1. The indicator light is red : the water supply is insufficient or unstable, and the
motor stops running.
2. The indicator light is green: the water supply is stable.
Run/pause/reset
1. The indicator light is on: the machine is operating normally
2. The indicator light is off : the machine stops running
3. The indicator light flashes : the machine is in wireless pairing mode
The indicator light is on, and the pump is in a pressure-holding state
1. The motor temperature is normal and the indicator light is green.
2. When the motor temperature exceeds the safe value, the indicator light turns
red and the motor stops running.
Original Language Version
B3
PW2400
C
D
Issue:1
18/01/22
Advertisement
