Turning The Sb-28 On And Off / Standby Function - Nikon SB-28 Instruction Manual

Turning the SB-28 on and off / Standby function

Turning power on and off
To turn the SB-28 on and off, depress and hold the = button for
approx. 0.5 sec.
Standby function
If both the SB-28 and camera are not used for after approx. 80 seconds,
the SB-28 shuts off automatically to conserve battery power. This is called
the standby function.
Canceling and setting the standby function
Press the = button for approx. 0.5 sec. to turn the SB-28 off.
1
Hold down the µ button as you press the = button.
2
—The SB-28's standby mode indicator : on the LCD panel appears when
the function is set and disappears when it is not set. Perform steps 1 and 2 to
cancel it or reset it.
• The standby function is preset when the SB-28 is shipped from the factory.
(Check that the standby mode indicator : appears on the LCD panel
when the SB-28 is turned on.)
When carrying the SB-28 in your camera bag with the standby
function set, make sure to turn off the flash unit to avoid accidental
battery drain.
To turn the SB-28 on again after it enters the standby mode,
you can:
• Lightly press the shutter release button (except cameras in Group VII).
• Press the ~ button on the SB-28.
• Press the SB-28's = button.
15