Advertisement

Philips Domestic Appliance and Personal Care
Service Manual

SERVICE POLICY

Product will be serviced for 3 years after End of Life.

PRODUCT INFORMATION

Easy-start

The brushing power will gently increase to full power over the
first 14 brushings.
The Easy-start feature is active if you hear 2 beeps immediately
after turning on your toothbrush.
Once you reach the optimal brushing power, after the 14
brushing, you will no longer hear the double beep at the
beginning of the brushing routine.
Easy-start can also be switched off. To deactivate and to
reactivate the Easy-start feature, see directions for use.

Smartimer

Automatically sets the brushing time to 2 minutes.
After these 2 minutes the product switches off automatically.
If you wish to pause, or stop brushing during the 2- minute
cycle, press the on/off button. When you press the on/off button
again, the Smartimer will pick up where you left off.

Quadpacer

The Quadpacer feature ensures that you brush all four sections
of your mouth evenly and thoroughly. You will hear a short
beep and notice a brief pause in brushing action. This is the
signal to move to the next section of your mouth. To deactivate
and to reactivate the Quadpacer feature, see directions for use.
Published by Philips Consumer Lifestyle
4235-057-54241 _ 11-05-12
(YY_MM_DD)
HX6150, Sanitizer
HX6902, FlexCare
HX6911, FlexCare
HX6912, FlexCare with Sanitizer
HX6930, (handle)
HX6932, FlexCare with Sanitizer
HX6952, FlexCare with Sanitizer

Programmable brushing modes

The programmable brushing allow you to customize the
brushing action. There are three different brushing modes.
Clean mode is the standard mode for superior teeth cleaning.
Sensitive mode provides gentle, yet thorough cleaning for
sensitive gums and teeth.
Massage mode provides gentle gum stimulation. .

Programmable brushing routines

The programmable brushing modes and routines allow you to
th
customize the length of brushing time. Choose 1, 2(factory
default) or 3 minute time intervals.
The 1-minute Go Care brushing routine has Quadpacer beeps
every 15 seconds.
The 2-minute Clean brushing routine has Quadpacer beeps
every 30 seconds.
The 3-minute Max Care brushing routine has Quadpacer beeps
every 45 seconds.
Note: The Quadpacer feature cannot be deactivated on the Go
Care and Max Care brushing routines.

Reminder bristles

Reminder bristles are introduced to remind the consumer to
replace their BHs at the recommended replacement time.
The color of the reminder bristles wears out as you use the
brush head and starts fading from the tip downward. When the
reminder bristles have faded half way it is time to replace the
brush head. After approximately 3 months of use.
Printed in the Netherlands
© Copyright Reserved
Sonicare toothbrush
Subject to modification

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HX6150 and is the answer not in the manual?

Questions and answers

Robert G Campbell
May 4, 2025

Our sonic are unit started beeping - it has never done that before ??

1 comments:
Mr. Anderson
May 17, 2025

The Philips HX6150 sonic unit beeps due to the Quadpacer feature, which provides beeps at set intervals during brushing routines. The 1-minute Go Care routine beeps every 15 seconds, the 2-minute Clean routine beeps every 30 seconds, and the 3-minute Max Care routine beeps every 45 seconds. Additionally, if Easy-start is active, two beeps are heard at the start of brushing for the first 14 uses as power gradually increases.

This answer is automatically generated

Summary of Contents for Philips HX6150

  • Page 1 HX6911, FlexCare HX6912, FlexCare with Sanitizer HX6930, (handle) HX6932, FlexCare with Sanitizer HX6952, FlexCare with Sanitizer Philips Domestic Appliance and Personal Care Service Manual SERVICE POLICY Programmable brushing modes The programmable brushing allow you to customize the Product will be serviced for 3 years after End of Life.
  • Page 2: Charging

    HX6150, HX6902,HX6911, HX6912, HX6930, HX6932, HX6952 Cleaning Do not place brush head, the handle or the charger in the dishwasher. Rinse the brush head and bristles after each use and allow to air dry completely. Remove the brush head at least once a week and clean the connection between the brush head and the handle and allow to air dry completely.
  • Page 3: Repair

    HX6150, HX6902,HX6911, HX6912, HX6930, HX6932, HX6952 REPAIR INSTRUCTION - Brush head (pos 3) In case of a defective brush head, the complete brush head must be replaced. - Charging unit (pos 2) To deplete the rechargeable battery of any charge,...
  • Page 4: Sanitizing

    It runs for 10 minutes then automatically shuts off. The sanitizer is in operation when the blue light glows through the Philips logo and the UV clean LED flashes slowly. Note: The sanitizer stops if the door is opened during operation.
  • Page 5: Parts List And Exploded View

    HX6150, HX6902,HX6911, HX6912, HX6930, HX6932, HX6952 PARTS LIST AND EXPLODED VIEW Pos Service Code Description Comments 4235 010 06902 TRAVEL CHARGER - US, CANADA Available as a Service part. Warranty claims should be routed to Call Centers. 4235 010 06912...
  • Page 6 HX6150, HX6902,HX6911, HX6912, HX6930, HX6932, HX6952 PARTS LIST AND EXPLODED VIEW, Cont’ Pos Service Code Description Comments 4235 010 07057 UV SANITIZER - US, CANADA Available as a Service part. Warranty claims should be routed to Call Centers. 4235 010 07237...
  • Page 7 HX6150, HX6902,HX6911, HX6912, HX6930, HX6932, HX6952 PARTS LIST AND EXPLODED VIEW, Cont’ 4235-057-54241 _ 11-06-29 (YY_MM_DD)

This manual is also suitable for:

Hx6911Hx6902Hx6912Hx6930Hx6932Hx6952

Table of Contents

Save PDF