Makita EM2650UH Technical Information page 4

R
epair
[4] DISASSEMBLY/ASSEMBLY
[4]-3. Shaft pipe complete
DISASSEMBLING
(1) Loosen two M6x30 Hex. socket head bolt (2pcs.) and remove Protector with Protector extension attached. (Fig. 7)
(2) Enlarge the space between the side wall of Protector cover and M5x14 Hex socket head bolt, and remove Protector cover
from Shaft pipe complete. (Fig. 8)
(3) Remove M5x14 Hex socket head bolt with Flat washer and spring washer then remove Protector clamp.
(4) Loosen M5x25 Hex socket head bolt then remove Gear case assembly. (Fig. 9)
(5) Remove four M5x30 Pan head screws then remove Loop handle and Handle clamp 24 from Shaft pipe complete. (Fig. 10)
(6) Remove four 4x18 Tapping screws and two M5x14 Hex socket head bolts then separate Lever case R and L. (Fig. 11)
(7) According to the clause of [4]-2, Remove Shaft pipe complete.
(8) Remove Hanger and Shaft from Shaft pipe complete. (Fig. 12)
Fig. 7
M6x30 Hex. socket
head bolt (2pcs.)
Protector
Protector extension
Fig. 9
M5x25 Hex
socket head bolt
Protector clamp
Fig. 11
Lever case set
M5x14 Hex socket
head bolt
4x18 Tapping screw
ASSEMBLING
Assemble in the reverse order of disassembly.
• Slip Hanger on Shaft pipe complete as drawn in Fig. 12.
Fig. 8
M5x14 Hex socket head bolt
with Flat washer and
Spring washer
The side wall of
Protector cover
Gear case assembly
M5x14 Hex socket
head bolt with Flat washer
and spring washer (2 pcs.)
Fig. 12
Note: Hanger has to be assembled to Shaft pipe complete
in direction of the following arrow.
The distance between a hole
and one pipe end is long.
Shaft
Shaft pipe
complete
Gear case
assembly
Fig. 10
M5x30 Pan head
screw (4pcs.)
Handle
clamp 24
Hanger
The distance is short.
Shaft pipe complete
P 4/ 14
Shaft pipe
complete
Loop
handle