Vacuum Switch; Igniter - England's Stove Works 25-IP Installation & Operation Manual

Vacuum Switch

1. Before beginning any component replacement, be certain the unit is unplugged and thoroughly
cooled down.
2. Remove the right side panel (see p. 43 for panel instructions).
3. Locate the vacuum switch as shown in the diagram below.
4. Disconnect the stove wiring harness and vacuum hose from the vacuum switch, taking note of
where connections were made.
5. Remove the two screws which hold the vacuum switch to the vacuum switch bracket, using a
phillips screw driver.
6. Installation is the reverse of removal; be absolutely certain the wires and vacuum hose are
connected according to the wiring diagram in this manual.

Igniter

1. Before beginning any component replacement, be certain the unit is unplugged and
thoroughly cooled down.
2. Remove the rear panel of the unit, using a
3. Loosen the bolts (in the front of the stove) that fasten the cradle (see also p. 31).
4. Locate the igniter as shown in the diagram below.
5. Disconnect the igniter wiring from the control board and use a
igniter retaining screw.
6. Loosen the allen set screw (
7. Install the new igniter in the igniter tube, retighten the set screw and reinstall the assembly
into the stove. Be certain to reconnect the new igniter wires to the circuit board before
reassembly.
8. Install the screw, locking in the assembly, and then tighten the bolts for the cradle...each one a
little at a time until the gasket is mated. Replace the panels.
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING CLEANING
THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT,
OR DUE TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY
REPLACING COMPONENTS
1
/ " allen wrench) and remove the old igniter cartridge.
8
QUESTIONS.
5
/ " wrench.
16
5
36
/ " wrench to remove the
16