Vacuum Switch; Igniter - England's Stove Works 25-EPI Installation And Operation Manual

Vacuum Switch

1. Before beginning any component
replacement, be certain the unit is
unplugged and thoroughly cooled
down.
2. Remove the right side panel and the
back panel as previously detailed.
3. Locate the vacuum sensor as shown
in the diagram below.
4. Disconnect the stove wiring harness
and vacuum hose from the vacuum
sensor, taking note of where
connections were made.
5. Remove the two screws which hole
the vacuum sensor to the vacuum
sensor bracket using a 5/16" wrench.
6. Installation is the reverse of removal;
be absolutely certain the wires and
vacuum house are connected
according to the wiring diagram in
this manual.
REPLACING COMPONENTS

Igniter

1. Before beginning any component
replacement, be certain the unit is
unplugged and thoroughly cooled
down.
2. Remove the right side panel and the
back panel as previously detailed.
3. Locate the igniter as shown in the
diagram below.
4. Disconnect the igniter wiring from
the control board and use a 5/16"
wrench to remove the igniter
retaining screw.
5. Loosen the allen set and remove the
old igniter cartridge.
6. Install the new igniter in the igniter
tube, retighten the set screw and
reinstall the assembly into the stove.
Be certain to reconnect the new
igniter wires to the circuit board
before reassembly.
Page | 39