Asus Z170-E Manual page 35

• The plugged USB 3.0 device will run on xHCI mode.
• USB 3.0 devices can only be used for data storage.
• We strongly recommend that you connect USB 3.0 devices to USB 3.0 ports for faster
and better performance from your USB 3.0 devices.
• Due to the design of the Intel
USB 3.0 ports are controlled by the xHCI controller. Some legacy USB devices must
update their firmware for better compatibility.
• Multi-VGA output supports up to three displays under Windows
displays under BIOS, and one display under DOS.
• Intel display architecture design supports the following maximum supported pixel
clocks (Pixel Clock = H total x V Total x Frame Rate (Screen refresh rate):
-
-
* LAN ports LED indications
Activity Link LED
Status Description
Off
No link
Orange
Linked
Orange (Blinking) Data activity
Orange (Blinking
Ready to wake up
then steady)
from S5 mode
** Audio 2.1, 4.1, 5.1, or 7.1-channel configuration
Headset
Port
2.1-channel
Light Blue Line In
Lime Line Out
Pink Mic In
Orange –
Gray –
Black –
ASUS Z170-E Series
®
DVI port: 148 MHz
HDMI port: 300 MHz
Speed LED
Status Description
Off
Orange 100 Mbps connection
Green
4.1-channel
Line In
Front Speaker Out
Mic In
–
–
Rear Speaker Out
chipset, all USB devices connected to the USB 2.0 and
10 Mbps connection
1 Gbps connection
5.1-channel
Line In
Front Speaker Out
Mic In
Center/Subwoofer
–
Rear Speaker Out
OS environment, two
®
ACT/LINK
SPEED
LED
LED
LAN port
7.1-channel
Side Speaker Out
Front Speaker Out
Mic In
Center/Subwoofer
Side Speaker Out
Rear Speaker Out
1-23