System Requirements; Hardware Installation - D-Link DCS-2100+ Quick Installation Manual

System Requirements

•
Internet Explorer 5.x or above
•
CPU: Pentium III, 500 MHz or above (Required for use with IP Surveillance software)
•
Memory Size: 64 MB (128 MB recommended)
•
VGA card resolution: 800x600 or above

Hardware Installation

Connect the Ethernet Cable
If you will be using the DCS-2100+ in a wired network,
connect an Ethernet cable to the network cable connector
located on the Internet Camera's back panel and attach it to
the network.
If you
directly to a PC, you will need a
cross-over Ethernet cable. If you plug the
camera into a hub or router, you will be able to
use the cable included with your camera.
Attach the antennas to the camera
If you will be using the DCS-2100+ in a wireless network,
attach the antennas to the back of the camera by turning
the antennas in the clockwise direction until snug, do not
over tighten.
connect this camera
2