D-Link DCS-2100+ Quick Installation Manual page 3

Hardware Installation (continued)
Attach the External Power Supply
Attach the external power supply to the DC power input
connector located on the Internet Camera's back panel
(labeled DC 12V) and connect it to an AC power outlet.
When you have a proper connection, the LED (Light Emitting Diode) on the front of the
camera will turn from red to green. The light may blink on and off and your computer may
show an intermittant loss of connectivity, this is normal until you have configured your
camera.
Power source is confirmed when
the LED Power Indicator on the
Internet Camera is illuminated.
Configuring your camera with IP
Installer
In the back of the camera, there is a hole for
reset. Lightly insert a paper clip into the
reset hole until the light starts to cycle (a
series of blinks) twice, then let go.
3