Gardsman CTC-1241GT Installation Manual page 64

Step 6. Enter the Control Command.
Step 7. Enter a space.
Step 8. Enter 00.
Step 9.You have now completed to edit the
command message. You can send it
to the panel.
Step 10. Wait for the panel send back a
confirmation message. The format will
be:
"Confirmation, (SMS keyword) (PIN Code)
(Control Command) 00"
Only when the Control Unit receives
valid command, confirmation message
will be sent.
< E X A M P L E >
< E X A M P L E >
If you send your control command in this
format:
Ex: Joe_11234_ 11_ 00
Joe SMS Keyword
__ Space
1 Area 1
1234 User pin code
__ Space
11 Enter Arm Mode
__ Space
00 confirmation
The Confirmation message will be:
"Confirmation, Joe 11234 11 00"
4.17.2. Without Confirmation Message
Step 1. Use your handset and go into the
SMS edit screen.
Step 2. Enter your SMS keyword, which is
programmed under the programming
menu.
Step 3. Enter a space.
Step 4. Enter your
corresponding User PIN code.
Step 5. Enter a space.
Area number and
Step 6. Enter the Control Command.
Step 7. You have now completed to edit the
command message. You can send it
to the panel.
< N O T E >
< N O T E >
The panel will not send any message
back to your handset.
4.17.3 Test Confirmation Message
When you finish programming the system, you
can use test message to confirm whether your
setting is correct.
Step 1. Use your handset and go into the
SMS edit screen.
Step 2. Enter your SMS keyword, which is
programmed under the programming
menu.
Step 3. Enter a space.
Step 4. Enter
corresponding User PIN code.
Step 5. Enter a space
Step 6. Enter 00.
Step 7. You have now completed to edit the
test message. You can send it to the
panel. You can send it to the panel.
Step 8. Wait for the panel to send back a test
confirmation message. The format will
be:
"Confirmation, (SMS keyword) (PIN Code)
00"
< N O T E >
< N O T E >
If the panel does not send a confirmation
message back to your handset, please take
a moment to check the following steps:
1) Remove the SIM card from the panel and
set it in your handset. Check if the SMS
memory space is full. It is recommanded to
empty the memory. Put the SIM card back
to the panel.
2) Check that the GSM singnal is detected.
3) Check the Country Code setting.
After you have checked the steps above, send a
test confirmation message again.
60
your Area number and