Configuring Wpa With Radius - NETGEAR WNDAP350 Reference Manual

Figure 19. Configure WEP Shared Key
5. Select the key to be used as the default key by checking the radio box. (Data transmissions
are always encrypted using the default key.)
6. Wireless Client Security Separation is disabled by default. If enabled, associated wireless
clients will not be able to communicate with each other. (This feature is intended for hotspots
and other public access situations.
7. Click Apply to save your settings.
Note: If you use a wireless computer to configure WEP settings, you will be
disconnected when you click Apply. Reconfigure your wireless adapter
to match the new settings or access the wireless access point from a
wired computer to make any further changes.

Configuring WPA with RADIUS

Not all wireless adapters support WPA. The wireless adapter hardware and driver must
support WPA. Consult the product document for your wireless adapter and WPA client
software for instructions on configuring WPA settings.

To configure WPA, follow these steps:
1. Under the Configuration tab, select Security on the main menu, select
the left-hand menu, and then select RADIUS Server Settings. The RADIUS Server
Settings screen displays.
2. Enter the RADIUS Server Settings as shown in
page 38.
3. Click Apply to save your RADIUS Server settings.
4. Under the Configuration tab, select Security from the main menu, and then select either
Security Profile Settings for 802.11b/bg/ng or 802.11a/na. The screen for the Profile Settings
ProSAFE Dual Band Wireless N Access Point WNDAP350
Basic Installation and Configuration
Configuring the RADIUS Server Settings
42
from
Advanced
on