NETGEAR WNDAP350 Reference Manual page 56

Figure 33. Restore to factory defaults
2. On the Restore Defaults screen, enable the Restore to factory default settings option by
selecting the Yes radio button.
3. Click Apply to reset to the factory default settings.
After a restore, the wireless access point password will be password, the default LAN IP
address will be 192.168.1.1, and the access point name will reset to the name printed on the
label on the bottom of the unit.
To restore the factory default configuration settings without knowing the login password or IP
address, you must use the Default Reset button on the rear panel of the wireless access
point (see Figure 1
• Reboot. When pressed and released, the Wireless Access Point will reboot (restart).
• Reset to Factory Defaults. This button can also be used to clear all data and restore all
settings to the factory default values.

To clear all data and restore the factory default values:
1. Power off the WNDAP350.
2. Use something with a small point, such as a pen, hold the Reset button for 5 seconds while
you Power On the WNDAP350.
3. Continue holding the Reset Button until the LEDs blink twice.
4. Release the Reset Button.
The factory default configuration has now been restored and the WNDAP350 is ready for
use.
ProSAFE Dual Band Wireless N Access Point WNDAP350
on page 12). The reset button has two functions:
Management
56