Panasonic EP-MA70 Operating Instructions Manual page 75

4
To repeat the current massage
Contents of current massage action will be repeated by pressing
• "REPEAT" command may not be accepted when the action is switching.
• will flash while massage is repeating.
5 Changing the intensity of the air massage
When performing a massage on shoulder, arm, lower back or legs,
Adjust by pressing the button.
• See pages 28 to 32 for effective method for using and operations of the air massage and leg stretch.
• Your preferred settings for these items can be registered and used. (See page 22.)
6
Fine adjustment of the position
(Number of adjustments possible)
• Adjustment may not be possible depending on the position.
3 times
3 times 3 times
3 times
7 To adjust the back intensity
Back intensity can be adjusted by pressing on the "+" or "–" of the Back Intensity.
• Current position that is getting massaged can be checked on the display.
• There are 3 levels of intensity for the Automatic courses.
• Intensity will not change further even if you keep pressing the button when the intensity is set to maximum
or minimum.
Caution
Intensity might increase drastically when the intensity is increased in multiple steps.
Always increase the intensity one step at a time, checking how it feels.
• For safety reasons, it is designed not to increase the intensity drastically.
• If you do not feel enough intensity even it is set to maximum, or you feel too much intensity even it is set to
minimum:
<When it does not feel strong enough even the intensity for Automatic courses is set to maximum>
You can massage with greater intensity by reclining the backrest and making use of your body weight.
<When it feels too strong even if the intensity for Automatic courses is set to minimum>
Pressure of the massage heads will soften by placing a cloth or blanket between the backrest and your body.
Also, if the intensity of the massage around your lower back is too strong, you can make it feel lighter by
pressing the Lower Back button for the Air Massage to release the air around the lower back.
• Your preferred settings for these items can be registered and used. (See page 22.)
Caution
You may not feel the difference in intensity for massage or stretch even if the Back (Intensity) adjustment or Air (Intensity)
adjustment button is pressed.
• When the intensity was increased right when the operation has changed.
• The feeling is different depending on the person or the position.
21
21-22
.
To register your preferences
Automatic courses
You can register your preferred settings set during the Automatic course, and have them reproduced next time you are
massaging.
You can register the settings for each course.
Example: When using "REFRESH" course
1. You have set Air Massage "SHOULDER" and "LEG/FOOT" to "On", and Stretch "CHEST" to "On".
(Air intensity was set to "Level 1" at this time.)
2. "Heat" massage heads was set to "Off", and Back intensity was set to "Level 3".
3. Volume for "voice guidance function" (see page 40) was set to "Loud".
4. These settings were registered to User after the massage completed.
Contents of the registered setting (1, 2, and 3 above) are restored if User
next time.
2
When the registration is completed
• Pressed button will turn off, and the power will be
turned off automatically in approximately 3 seconds.
• Be careful since registered contents will not be saved
when the power switch is turned "Off" or the power cord is
disconnected during the massage.
Contents that can be registered
• Air intensity and Back intensity settings
• "Heat" Massage Heads off/on setting
• Air and Stretch off/on settings
(See pages 20–21.)
• Voice guidance volume setting (See page 40.)
* V alues set at the time the Automatic course is
completed will be registered.
About the "Heat" massage heads and Voice
guidance volume settings
Only these 2 settings will be applied to all the
Automatic courses.
As an example, the settings "Heat" massage heads
"Off" and Voice guidance volume "Loud" set for User
for "REFRESH" in the above " Example" will be
applied.
(Settings for Air and Stretch are not affected.)
is pressed when "REFRESH" course is used
1
After the Automatic course has finished,
or when the massage is completed by
pressing during the course
: Y our preferred settings (pages 20–21, 40 (volume)) are
displayed and the User buttons will flash.
2
Select and press one button from
that you would like to
register while the buttons are flashing
(approx. 15 seconds).
• Selected button will light. (Example: )
If there is another setting already registered, "Other
settings are already registered." will be announced.*
To update to contents of new setting*
Press the same button again.
Press.
* T his will also be announced when you try to register to a
separate Automatic course or same Automatic course
contents that are the same as those already registered.
If you do not want to delete the setting already
registered.
Press the other User button.
Press.
22
2010/12/28 11:24:34