Panasonic EP-MA70 Operating Instructions Manual page 74

1
Body scanning will commence when the program is selected. (
• The body scanning will properly detect height ranges between approximately 140 and 185 cm.
Sit as far back in the seat as possible
with your head on the pillow.
1
2
3 Adjust the pillow height so that
4 the bottom edge of the pillow is
at ear level.
See page 17.
1 NECK (Neck) 3 MIDDLE BACK (Back)
2 SHOULDER (Shoulder) 4 LOWER BACK (Lower
back)
2
Approximately 30 seconds after the body scanning starts, the massage heads slowly lower to the
shoulder position, and a soft tapping action begins to determine your shoulder position.
Massage Head
Tapping
action
• Air in the seat will operate so the body will not shift during
the body scanning.
3
To adjust the shoulder position during the tapping action
• When the shoulder position is incorrect, adjust then shoulder position while the soft tapping is in progress (for
approximately 12 seconds), and use the POSITION button to move the massage heads up or down and then press
button.
A single press of
the button will
raise or lower the
massage heads
approximately
1.2 cm.
4 Body scanning is completed when the tapping finishes.
• If you press while the tapping action is still going on, it will end the body scanning and the massage will start.
• The legrest adjusts automatically so that the soles of the feet touch the footrest wells according to your estimated
height based on the shoulder position.
• If the shoulder position is off drastically, turn the power off once, and repeat from Step 1 with shoulder firmly pressed
against the backrest.
19
19-20
will flash.)
The unit will automatically recline to the correct
massage position.
Correct Massage Position
Reclined
approx. 12°
Raised
approx. 55°
• If the massage lounger is reclined further than the
massage position angle, it will not automatically return
to the correct massage position.
• Keep your head on the pillow until the soft tapping
begins. Lifting your head from the pillow will result in
incorrect determination of the shoulder position.
Too high
Correct position of the
massage head
(The point where the
tapping action should
be felt.)
Too low
To customize
1
2
3
4
5
6
7
1 Adjusting the reclining angle and
legrest to massage in relaxing position
To adjust the reclining angle and the legrest angle:
Adjust by pressing button.
To adjust the amount of sliding of the sole
massage section:
Push with the soles of
your feet to slide the
legrest out.
Lift your soles slightly and legrest returns.
• See page 33 for description on how to adjust the
reclining angle and the legrest.
2
Setting the off/on of the air massage
or the stretch massage
Operation can be turned off/on by
pressing buttons on the left.
Off/on for the air massage or stretch
can be confirmed on the display.
(Lit: On, Off: Off)
Chest
Shoulder
Hand/
Arm
Hip
Lower
back
Leg
Leg/Foot
• Your preferred settings for these items can be registered and
used. (See page 22.)
3
To turn off/on the "Heat" massage
heads
You can turn off/on the "Heat" massage heads by
pressing .
Flashing: Warming up "Heat" massage heads.
Lit: "Heat" massage heads are on.
Off: "Heat" massage heads off.
• Temperature cannot be adjusted.
• Sense of warmth from the massage heads will differ
depending on your body shape, massage area, massage
action, clothing, and ambient temperature.
• See page 24 for details about "Heat" massage heads.
• Your preferred settings for these items can be registered and
used. (See page 22.)
20
2010/12/28 11:24:34