Panasonic EP-MA70 Operating Instructions Manual page 71

6 Placing the controller
1
Placing the controller into the
controller stand.
2
Fasten the controller cord
using the clip.
• Fasten so the cable under the clip will not
sag too much with the backrest raised.
(Because there is a chance of your legs,
etc., getting caught)
When the controller stand is attached on the left side
• Run the controller cord to the left.
1
Press the button on the controller to turn on
the power.
2
Press button on the controller and hold
until the legrest has risen far as it will go.
• Continue pressing until a "beep-beep-beep" sound is heard.
3
Disconnect the controller cord.
• Hook is released by pressing on the tab on the fastening band with your fingers.
4
Move the controller cord under the legrest to
the left side.
5
Fasten the controller cord.
• Press down from the edge if it does not fit in easily.
6
Insert the tip of the fastening band into the hole.
• The controller cord is fastened to the right side prior to leaving the
factory.
Fastening band Fasten to the right side
3
3
Tab
Controller Cord
13
13-14
1 1
Legrest
2 2
View from front
Cord-Holder Groove
6
Controller Cord
4
7 Fasten the pillow and the comfort cushion.
1
Fasten the pillow using the
fasteners.
• See page 17 for guidelines on positioning the
pillow during the massage.
Fasteners
Pillow
2 2
5 5
2
Fasten the comfort cushion using the
zipper.
Fasteners Zipper
Comfort cushion
14
2010/12/28 11:24:31