Assembly
1 Attaching the controller stand to the right or left side panel of this unit
Fasten the controller stand with the
attachment screws. (4 positions)
Use this screw: A ttachment screws (M6 × 13)
× 4 pcs. (Black)
How to tighten the screws
Attachment screw
•
Tighten the 4 screws lightly
using your fingers.
Hole
(Make the screws level with
the holes.)
Allen key
•
Tighten firmly with the allen
key.
•
Screw may be damaged if
you tighten the screw
inserted into the hole
crookedly using an allen key.
2 Fasten the armrest with the attachment screws. (On both the right and left sides)
1
Insert the armrest into the unit.
•
"R" (right side) and "L" (left side) are indicated at the bottom of the
armrest.
•
Insert the armrest from the top aligning the
marks on the side of
the armrest.
•
Be careful to avoid pinching your fingers and air plugs.
2
Slide the armrest toward the front while
pushing it downward.
3
Fasten the armrest with the attachment
screws. (One position for each side)
Use this screw: A ttachment screws (M6 × 20)
× 2 pcs. (Silver)
How to tighten the screws
•
Put an attachment screw on the
Allen key
edge of the allen key and tighten the
screw horizontally to the hole.
•
Screw may be damaged if you
tighten the screw inserted into the
hole crookedly using an allen key.
11
11-12
<When attaching on the right side panel>
•
Align the 2 prongs of the
Controller
side panel with the holes of
Stand
the controller stand.
<When attaching the right armrest>
1
Front
Back
Align the
marks.
2 2
3 3
3 Connecting the air plugs (On both the right and left sides)
•
Insert the air plugs into the lower part of the armrest.
* Arm massage will not operate unless the air plugs are inserted securely.
4 Connect the power cord to the unit
1
Check for dirt and damage on appliance inlet of
Appliance inlet
the power switch section and the connector of
the power cord.
2
Insert the connector into the appliance inlet.
Connector
3
Be sure to push the connector in all the way.
Power cord
Power switch section
5 Raising the backrest to the upright position
1
Insert the power plug into the
power outlet.
2
Confirm the lock switch key is
set to the "open" position.
3
Confirm the power switch is set
to the "on" position.
4
Press
button on the
controller twice.
•
Press once, and then press again approx.
1 second later.
Backrest will rise automatically.
View from bottom
Air plug jack
Front
Air plug
Push on the air plugs
until you hear it click
into place.
1
2
3
12
2010/12/28
11:24:31